AML M3000 Podręcznik Użytkownika Pobierz pdf (Strona 36)

4Quick Start - Basic Operations

4-9

e) Press EXIT twice. The display shows:

Serial Wedge

The M3000 is setup for Serial Wedge operation and ready to send bar code data

to your computer.

3. Scan a bar code label. The M3000 beeps to signal a good read. Data from the input

device is sent to the computer just as if the data had been typed at the terminal.

NOTE: During Serial Wedge operation, only data from a scanning device is

sent to the computer. The M3000 does not send out data entered on

the keypad by default, but can be enable by using the Wedge Kypad

option in setup.

RS-232 Serial Mode

When the M3000 operates in the RS-232 mode, bar code data is transmitted serially to the host

computer. If your computer software does not require keyboard emulation your M3000 is ready

for operation. If your system requires keyboard emulation, you should install the SOFTCOM

program that was shipped with the M3000.

Refer to Communications, for installation instructions. SOFTCOM requires an MS-DOS, PC-

DOS or other DOS compatible operating system, version 2.1 or higher.

To operate the M3000 in the RS-232 Serial Mode perform the following:

1. Press ON. The display shows:

Portable Mode

Select Function

2. Press SHIFT. The M3000 displays the current non portable mode. If the display does

not show:

RS232 Serial

you have to change the non portable mode setup. To change the non portable mode to

RS-232 Serial, do the following:

a) Press FUNCTION, then SETUP. The display shows:

Setup Selection

>Date/Time

b) Press the Down arrow once. The display shows:

Setup Selection

>Nonport. Mode

c) Press Enter to select the non portable mode setup option.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 155 156

Brak uwag

AML M3000 Podręcznik Użytkownika Strona 36