AML M3000 Podręcznik Użytkownika Pobierz pdf (Strona 91)

6Setup Procedures

6-23

Data Bits

This option sets the character length (number of data bits per character) for the serial data. The

M3000's Data Bits setting must match the data bits setting of the attached computer's serial

interface. Select one of the following:

Parity

The M3000's Parity setting must match the parity setting of the attached computer's serial

interface. Select one of the following:

NONE* EVEN

ODD MARK

Stop Bits

This option sets the number of Stop Bit characters for the serial data. Select one of the following:

Character Delay (Char Delay)

Character Delay (also known as inter character delay) specifies the amount of delay that the

M3000 inserts between each transmitted character. This option slows the transmission rate to

compensate for slow host computers that require more time to process each character.

Default setting = 1 millisecond

Programmable range: 0ms - 99ms

Duplex

The Duplex setting determines whether the M3000 sends data to the Host only, or to both the Host

and Terminal. The M3000's Duplex setting must match the duplex setting of the Terminal's serial

interface.

FULL* In the Full Duplex mode data is sent only to the Host. The host computer receives the

data and echoes it back to the terminal.

HALF In the Half Duplex mode data is sent to both the Host and Terminal at the same time.

Modem TmOut

The Modem Time Out, when set to "ON" aborts the Transmit Receive mode after approximately 4

Min. 15 Sec, if a call is not received. The M3000 must be connected to a modem, and operating

in the Transmit Receive Mode for this feature to take effect.

ON The M3000 aborts Transmit Receive after approximately 4 Min 15 Sec when a call is

not received.

OFF* The M3000 waits for a call indefinitely.

Caps Lock

Use this option to match the terminal keyboard's CAPS LOCK status.

ON * Select ON when the terminal keyboard's CAPS LOCK is turned ON. This setting

transmits lower case Alpha characters as Shifted characters.

OFF Select OFF when the terminal keyboard's CAPS LOCK is turned OFF. This setting

transmits upper case Alpha characters as Shifted characters.

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 155 156

Brak uwag

AML M3000 Podręcznik Użytkownika Strona 91